EN UA
Hot Line: 8 800 200 05 65


Products

AKSI ROOF V, AKSI ROOF, AKSI ROOF N

AKSI ROOF V, AKSI ROOF, AKSI ROOF N

Areas of application

AXI ROOF slabs are designed to be used in civil and industrial construction as heat insulation in coverings with reinforced concrete flooring. Before waterproofing installation on a heat insulation layer, install protective underlayment. The heat-insulation layer of roofing structures with application of slabs may be single-layered and multilayered. The top layer may be made of AXI ROOF V slabs; in this case, the roof cladding is installed without any additional protective underlayment.

AXI ROOF N slabs are designed to be used in civil and industrial construction as a heat insulation bottom layer in coverings for two-layer thermal insulation. Recommended to be applied in combination with AXI ROOF V slabs.

AXI ROOF N and AXI ROOF slabs are recommended to be applied as the bottom layer.

Description

AXI ROOF are extra rigid, nonflammable, waterproofing, heat- and sound insulating slabs made of basalt rock stonewool with a low-phenol binder.

AXI ROOF N are extra rigid, nonflammable, waterproofing, heat- and sound insulating slabs made of basalt rock stonewool with a low-phenol binder.

Storage

The slabs must be stored in covered warehouses. Storage under an awning protecting the slabs from atmospheric precipitation is permitted. slabs during storage should be laid in containers or in piles on pallets or linings. The piling height during storage should not exceed 2 m.



Types of material

    AXI ROOF N

    AXI ROOF V

    AXI ROOF


Basic physical and mechanical properties

PropertyAXI ROOF NAXI ROOF VAXI ROOF
Compression strength at 10% deformation, kPa, not less than60 100 80
Flammability gradeNG NG NG
Thermal conductivity, W/m*C 250,0410* 0,0422* 0,0418**
A0,046* 0,047* 0,047**
B0,049* 0,050* 0,050**
Interlaminar strength, kPa, not less than10 15 12
Compression strength at 10% deformation after sorption moistening, kPa, not less than48 80 64
Vapor permeability, mg/(m*h*Pa), not less than0,28 0,35 0,3
Humidity by weight, %, no more than0,5 0,5 0,5
Water absorption by weight no more than, %10 10 10
Water absorption by volume, %, no more than1,5 1,5 1,5
Content of organic substances, %, no more than4,5 4,5 4,5
Density, kg/m3135150 180-200 155-175
Length, mm 1000 1000 1000,1200
Width, mm 500, 600 500, 600
Thickness (with increments of 10 mm), mm50-100 50-100

* According to the NIISF RAASN Protocol #12 dated March 27, 2006.

** According to the NIISF RAASN #12-1 Protocol dated 27.03.06.